Dryer · Safe first checks
Why is my dryer running but not heating?
A tumbling dryer with no heat may be on a no-heat setting, have restricted airflow or have a power or heating-system fault. Damp clothes can also come from overloading or a washer that leaves them very wet. These are different problems, so note whether the air is cold or simply drying slowly.
WEPAIR AI editorial guide · Last updated · General guidance, not a model-specific diagnosis
Cold air or slow drying?
Air Fluff intentionally runs without heat. A heated cycle that stays completely cold needs a different assessment from a warm dryer that takes too long. Keep the cycle name, load size and whether the washer spun normally ready for the technician.
Safe checks you can do
Check the selected cycle
Choose a heated cycle allowed for the fabric. Air Fluff or No Heat is not a heating fault. Sensor cycles may end early with very small loads; follow your manual’s timed-cycle guidance.
Clean the lint screen
Remove lint before each load. If your manual permits washing residue off the screen, dry it fully and reinstall it before use. Never run the dryer without its lint screen.
Look at accessible venting
Switch off and unplug before inspecting a visible vent hose. Look for crushing or kinks without moving a gas dryer or disconnecting it. A blocked wall duct needs qualified vent cleaning.
Check the outdoor outlet safely
For a vented dryer, observe the outlet from ground level during normal operation only if no fire warning is present. Weak airflow suggests restriction. Do not climb or reach into a running duct; condenser and heat-pump dryers use different maintenance instructions.
Check power once, if safe
Some electric dryers can tumble while one part of their supply is lost. At a dry, undamaged panel, a tripped dryer breaker may be reset once according to the manual. If it trips again, leave it off and get qualified electrical help.
Compare with a smaller load
When airflow and safety checks are clear, try a normal smaller load on the correct cycle. Very wet clothes from the washer can make drying slow even when the dryer heats normally.
When to stop and call a professional
- A heated cycle still produces no heat after settings and safe airflow checks.
- The dryer is scorched, smells burnt, overheats or trips its breaker again.
- Gas odor, damaged venting or a suspected internal heating fault is present; do not test igniters, fuses or elements yourself.
Seeing an error code?
Use the manual or manufacturer support page for your exact model. Code meanings vary; this guide does not assign a meaning to a manufacturer-specific code. Share the exact model and what happened before the code with your repair professional.
Sources and model instructions
Manufacturer links describe their own products. Use your model’s instructions where designs differ; these references do not imply an affiliation with WEPAIR AI.
Spotted something wrong or out of date? Report a correction so we can check it against the sources.
Related repair guides
Still stuck with your dryer?
Tell WEPAIR AI what is happening and which checks you have tried. Add a photo if it helps. The free troubleshooter can suggest safer next steps and help you decide when a repair professional is needed. AI can make mistakes.
Try the free troubleshooter