Dishwasher · Safe first checks

Why won’t my dishwasher start?

A dishwasher that won’t start is often waiting on something simple: power, a door that isn’t fully latched, the water supply, a control lock or a delay-start timer. Check these, then try a reset. If it still won’t start, the latch, controls or wiring need a technician.

WEPAIR AI editorial guide · Last updated · General guidance, not a model-specific diagnosis

Lights on or off?

No lights at all suggests power. Lights that come on but no cycle suggests the door, the control lock, delay start or the water supply. A flashing lock light usually means buttons are locked, not broken.

Safe checks you can do

  1. Check the power

    Make sure a plug-in dishwasher is plugged in. For a hard-wired one, check whether its breaker has tripped and reset it once.

  2. Latch the door fully

    Close the door until it latches. A lower rack put in backwards or an item sticking out can stop the door from closing.

  3. Check the water supply valve

    Many dishwashers won’t run a cycle if they don’t detect water. Make sure the supply valve under the sink is on.

  4. Turn off the control lock

    If a lock symbol is lit, the buttons are disabled. Your manual shows how to unlock — often by holding one button for a few seconds.

  5. Cancel a delay start

    If delay wash was set, the dishwasher waits for the timer. Press Cancel/Drain to clear it and start again.

  6. Reset it

    Press Cancel, then unplug it or turn off its breaker for about one minute and restore power. Try a normal cycle once.

When to stop and call a professional

  • It still won’t start after the checks and one reset.
  • The breaker trips again, or there is a burning smell or water near electrical parts.
  • The door latch is broken or the display shows a service error code.

Seeing an error code?

Use the manual or manufacturer support page for your exact model. Code meanings vary; this guide does not assign a meaning to a manufacturer-specific code. Share the exact model and what happened before the code with your repair professional.

Sources and model instructions

Manufacturer links describe their own products. Use your model’s instructions where designs differ; these references do not imply an affiliation with WEPAIR AI.

Spotted something wrong or out of date? Report a correction so we can check it against the sources.

Related repair guides

Still stuck with your dishwasher?

Tell WEPAIR AI what is happening and which checks you have tried. Add a photo if it helps. The free troubleshooter can suggest safer next steps and help you decide when a repair professional is needed. AI can make mistakes.

Try the free troubleshooter